1. Select, set up, put on and lock

Measure the chain width with the template, select the right brushes according to the template color and put them into the KETTENMAX (bottom box).



Assemble the upper and bottom box at an easy accessible point (according to motorcycle type in front or behind the bed of tire) and lock with the rubber band.





Then screw the drain bag onto the KETTENMAX (bottom box).

2. Hanging and securing

Ideal: Hang at the front and at the rear, and stretch with the quick release fastener. Rotation is possible in both directions.





Hang according to type of motorcycle only in the front or at the rear. Rotation is only possible in one direction.

3. Cleaning

Attach the screw cap with nozzle to the bottle of cleaner, connect hose with nozzle and Y-distributor, connect hoses with Y-distributor and KETTENMAX.

Always connect the hoses to the upper (chain ingoing side) and bottom nozzle connection at the KETTENMAX. With change of rotation direction: reverse the upper hose.

Supply cleaner proportional, rotate the rear wheel slowly (2 x chain run per minute). A gentle overall cleaning of the chain is ensured.

5. Lubricating

Put the lubricating adapter on the upper nozzle connection on the KETTENMAX (chain outgoing side). Spray in the lubricant in steps. Rotate the rear wheel slowly (2 times per minute). The lubricant accurately coats the important inner side of the chain and is evenly distributed by brushes.

Contaminated cleaning solution and any excess lubricant will be drained into the drain bag and appropriately disposed of in an environmentally friendly manner.

After finishing the cleaning and lubricating process, remove the spray and lubricating adapter from the KETTENMAX. Remove the drain bag and close with the screw cap. Disassemble the hooks, cords and KETTENMAX carefully.